Runner Adjuster Units
Products
6
S4120 Runner selector
€86.80*
S4120_A:
14
With the runner selector the cold runner sprue can be blocked from the mould parting line or its desired alignment can be adjusted.
This is done by reinserting the treaded part after setting the desired flow channel direction or locking it in a 90, 180 or 270° position in the intended receptacle of the runner selector body. The functional part then remains blocked in the set position.
All runner selectors have an H7 bore for using an ejector pin Ø 5 mm as an ejection aid for the cold runner.
S4121 Runner selector
€98.00*
S4121_A:
18
The technical design of this runner selector corresponds to the solution S4120/…, but as a variant it also offers a cooling option for the ejector pin in the runner selector body, so that less heat is transferred from the mould via the ejector to the cold runner sprue area.
The circumferential recess is suitable for cooling water flows up to Ø 8 mm. Sealing is via 2 integrated O-rings.
S4122 Runner adjuster unit with hole
€0.00*
S4122_SW:
5
|
S4122_Typ:
Ohne Hinterschnitt
|
S4122_a1:
30
|
S4122_a2:
11
|
S4122_b1:
22
|
S4122_d1:
16
|
S4122_d2:
5
|
S4122_f:
4,2
|
S4122_h1:
46
|
S4122_h2:
14
|
S4122_h3:
10
|
S4122_h4:
7
|
S4122_h5:
25
Our runner adjuster unit with hole allows a quick shut-off in case of defected cavity in a big multi cavity mold. The production can be continued, till the operator takes time to repair the defected cavity.With undercut for the ejection process of the cold runner sprue. S4122/OH hole without undercut. The mounting of this unit goes into the moving mold half.
S4123 Runner adjuster unit without hole
€0.00*
S4123_SW:
5
|
S4123_a1:
30
|
S4123_a2:
11
|
S4123_b1:
22
|
S4123_d1:
16
|
S4123_f:
4,2
|
S4123_h1:
66
|
S4123_h2:
14
|
S4123_h3:
7
Our runner adjuster unit with hole allows a quick shut-off in case of defected cavity in a big multi cavity mold. The production can be continued, till the operator takes time to repair the defected cavity. With undercut for the ejection process of the cold runner sprue. S4123/OH hole without undercut. The mounting of this unit goes into the moving mold half.
